Expert Resources & Tools

SpecPros Blog

Basic Facts About Cures & Sealers

Cure and seal products are used to help freshly placed concrete retain moisture during the curing process while also providing surface protection after placement. When applied correctly, they can improve hydration, reduce surface defects, enhance appearance, and make concrete easier to clean and maintain.

These products are commonly used on exterior concrete, commercial slabs, decorative concrete, sidewalks, driveways, and other flatwork where curing performance and finished appearance both matter.

Why Should You Cure Concrete?

Curing is one of the most important steps in achieving durable concrete. Fresh concrete needs adequate moisture to properly hydrate and develop strength. If moisture leaves the slab too quickly, the surface can become weaker and more prone to cracking, dusting, scaling, curling, and crazing.

Proper curing helps:

  • Support maximum strength and durability.
  • Reduce plastic shrinkage cracking.
  • Minimize dusting, scaling, curling, and crazing.
  • Promote more uniform color and appearance.
  • Improve long-term surface performance.

Applying a cure and seal shortly after final finishing helps protect the concrete during this critical early stage while also improving the finished surface.

Cure & Seal Application Procedures

When used for curing, cure and seal products should be applied as soon as surface water has disappeared and the concrete surface will not be marred by the applicator. Apply the material evenly at the specified coverage rate using a low-pressure sprayer with a wide-angle fan tip nozzle.

Avoid puddling. If material collects in low spots, use a lamb’s wool roller or pad to distribute it evenly. For enhanced curing and sealing protection, a second coat may be applied after the first coat has thoroughly dried. Apply the second coat at a right angle to the first coat for more uniform coverage.

When used as a sealer only, the concrete surface must be clean, dry, and free of oil, grease, dirt, stains, and incompatible coatings before application. Cure and seal products can also help refresh existing concrete, brick, or terrazzo surfaces by improving appearance and making the surface easier to maintain.

Water-based cure and seal products should be thoroughly agitated before use. Do not mix with a high-speed mixer. These products should not be allowed to freeze. Low-odor, water-based options are often suitable for both interior and exterior applications.

What is ASTM C-1315?

ASTM C-1315 is the standard specification for liquid membrane-forming compounds that cure and seal concrete. It replaced TTC-0800 as a common curing and sealing specification used in the industry.

ASTM C-1315 classifications include:

  • Type I: Clear or translucent.
  • Type II: White pigmented.
  • Class A: Non-yellowing, Gardner Color Standard No. 1.
  • Class B: Moderate yellowing, Gardner Color Standard No. 3.
  • Class C: Severe darkening and yellowing.
  • Minimum solids content: Type I and Type II products must have at least 25% solids.

Choosing the Right Cure & Seal

The best product depends on the project conditions, desired appearance, application environment, and performance requirements. For new concrete, timing and coverage are critical. For existing concrete, surface preparation is just as important.

A properly selected and applied cure and seal can help protect the surface, improve appearance, reduce maintenance needs, and support long-term concrete durability.

Social Media

Browse Articles by Topic

Subscribe to SpecPros