SpecChem > Products > Specialty Epoxies > SpecPoxy 2000

SpecPoxy 2000

ASTM 881 compliant hi-mod, medium viscosity epoxy

SpecPoxy 2000 is a two-component, multi-purpose, high-modulus, moisture-tolerant epoxy bonding adhesive that meets ASTM C881 requirements for Types I, II, IV & V, grade 2, classes B&C. This medium-viscosity, 100% solids, solvent-free adhesive is designed for a range of uses including bonding fresh concrete to hardened concrete, anchoring bolts, dowels, and reinforcing steel, and gravity filling cracks in concrete.

  • VOC content = 0 grams per liter, highlighting its environmental safety.
  • Effective for bonding various materials and performing structural repairs.
  • Can be used for anchoring and crack filling applications.
  • Medium viscosity allows for easy application and excellent penetration.

Tech Sheet
Safety Sheet
Spanish Tech Sheet


Mixing Instructions:

  • Premix each component separately, then mix one part of Part A with one part of Part B for three minutes using a low-speed drill.
  • Ensure all materials are at least 40°F prior to mixing and installation.

Surface Preparation:

  • Surfaces must be clean and structurally sound, free from oil, grease, dirt, and other contaminants.
  • Recommended methods include abrasive blast cleaning and mechanical removal.
  • Ensure drilled holes are cleaned out with a cylindrical bristle brush and oil-free compressed air.

Application Techniques:

  • Bonding: Apply at a rate of 80 sq ft per gallon, approximately 20 mils in thickness. If not tacky, reapply after cleaning the surface.
  • Anchoring: Use appropriate hole depths and ensure no air pockets or voids. Mix with silica sand for patching repairs.


  • Available in 1 gallon units, 2 gallon units, 10 gallon units, and 22 oz. dual cartridges.

Shelf Life

  • Store in original, tightly closed containers in a clean, dry area. Properly stored, the shelf life is two years from the date of manufacture.

Test Data

  • ASTM Compliance: Complies with ASTM C881 for high-modulus, medium viscosity applications.
  • Initial Cure: 24 hours
  • Final Cure: 7 days
  • Compressive Strength (ASTM D695): 10,250 psi
  • Compressive Modulus (ASTM D695): 450,400 psi
  • Bond Strength (ASTM 882): 2 days – 1,790 psi; 14 days – 3,220 psi
  • Elongation (ASTM D638): 1.9%
  • Tensile Strength (ASTM D638): 7,050 psi
  • Water Absorption (ASTM D570): <0.15%
  • Heat Deflection (ASTM C648): 135°F